Cellulose separator for cells, low Equivalent series resistance (ESR) type.
Product Benefits
High reliability type, Lower ES
High electrolyte holding ratio type
Technical Data (Typical Properties)
Basic Film Properties
Unit of Measure
Typical Value
Thickness
μm
25
Density
g/cm3
0.44
Porosity (calculated)
%
71
Moisture
%
7-10
Tensile Strength
N/15mm
10.3
Air Resistance
sec/100cc
109.6
Water Absorption
mm/10min
35
pH
–
6.2
Remark
Because TF is made from cellulose, it tends to absorb moisture, and depending on circumstances, it might contain 7-10% moisture. When assembling cell with TF, sufficient drying is required. Recommended drying condition is in the range of 100-160°C within 24 hours by vacuum drying. After drying procedure, please handle the products under the low dew point environment. Recommended dew point is less than -60°C. In the drying procedure, the products may shrink about 1% lengthwise and widthwise, so please design your product after taking this shrinkage into consideration.
Download Material Safety Data Sheet:
Download Technical Data Sheet:
Size
Width 60mm*Length 50m, Width 60mm*Length 100m, Width 100mm*Length 100m
